This step is only required once for a Hyper-V server. Open the virtual machine's network configuration file located in /etc/network/interfaces.Įdit the file so that it reflects the configuration below (please remember to fill in your own values). Step 4: Configure the virtual machines DebianĬonnect to the shell of your virtual machine. Now you can start the VM and proceed with the configuration steps, depending on the operating system installed.
FIND THE MAC ADDRESS FOR UA SCALE MANUAL
VMware ESXiĪfter you've created the virtual machine and while it's powered off, right click the VM and click Edit settings.įold out Netwok Adapter 1, change the value in the MAC Address drop-down menu to Manual and enter the MAC address created previously. Then add the vMAC address created previously. For example, if your server's main IP address was:įor all operating systems and distributions, you must configure your virtual machine with the virtual MAC address you have created in the OVHcloud Control Panel.Īfter creating the VM and while it is still powered off, right-click the VM and click Edit settings.
The gateway IP address is made up of the first three octets of your server's main IP address, with 254 as the last octet. To configure your virtual machines for internet access, you will need to know the gateway of your host machine (i.e. Type a name in the “Name of virtual machine” field, and click on Confirm. in the relevant row to open the context menu, and select Add a virtual MAC.Ĭhoose ovh from the "Type" drop-down menu unless you are using VMware ESXi - in that case choose vmware. Then click on IP in the menu on the left-hand side and locate your failover IP address in the table.Ĭlick on. Log in to the OVHcloud Control Panel and switch to the Bare Metal Cloud section. GATEWAY_IP = The address of your default gateway.FAILOVER_IP = The address of your failover IP.SERVER_IP = The main IP address of your server.configuring the IP address, netmask, gateway and route to the gateway inside the VMĬode samples in the following instructions have to be replaced with your own values:.setting the MAC of the VM to that new virtual MAC address.creating a virtual MAC address for a failover IP.The basic steps are always the same, independent of the underlying system: at least one failover IP address attached to the server.VMware ESXi, Citrix Xen Server, Proxmox, etc.) a dedicated server with a hypervisor installed (e.g.
FIND THE MAC ADDRESS FOR UA SCALE HOW TO
This guide will explain how to use network bridging to configure internet access for your virtual machines.
Some tweaking is necessary to make the network configuration work on our network. Bridged networking can be used to configure your virtual machines.
0 kommentar(er)
